Inventum NB435B Mode D'emploi page 13

4
using the mixer
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the
appliance.
1. Place the mixer on a flat, clean and dry surface.
2. Make sure that the mixer is not activated.
3. Place the ingredients in the jug and lock it with the lid. Place the jug onto the base and turn it clockwise,
until you feel it click into place.
4. Activate the mixer by choosing a speed setting.
Attention: Do not activate the mixer constantly, this can cause engine problems. Do not use the mixer for
more then 1 minute continuously, wait 1 minute before you operate it again.
5. When the mixer has finished mixing, blending or crushing turn the control button OFF (0) and wait until the knives have stopped
turning, before you remove the jug.
5
tips
• When the jug is cracked, do not use the mixer anymore. This could lead to damage while using the mixer.
• To avoid splashes always place the lid on the jug.
• Always add liquid ingredients before adding solid ingredients in the mixer.
• The mixer mixes best when you do not add pieces which are too large.
• Always add a half a cup of liquids when you crush ice cubes.
• To add ingredients while the mixer is activated, take the cap out of the lid and add the ingredients through the opening.
• When the ingredients stick to the sides of the jug or are not mixed properly, shut off the engine: wait until the knives have stopped
turning and push the ingredients with a spatula towards the knives.
• To prevent the ingredients from being blend to small, take into account that the mixer mixes in seconds, not minutes!
• Working with warm ingredients can cause a build-up of pressure in the jug and that can cause hot liquids to escape when you take
the lid of the jug. Therefore always remove the cap from the lid when you are processing warm ingredients.
6
cleaning & maintenance
Always unplug the cord from the socket before cleaning the appliance.
• Wipe the base with a damp cloth. Do not use any abrasive or strong detergents.
• Never place the appliance, the power cable or the plug in water or any other liquid.
• Remove the knives according to the instructions below. Be careful, the knives are extremely sharp. Clean the knives as a whole do
not try to take them apart. Attention: do not use any abrasive or strong detergents.
• For placing and removing the knives you need the glass jug and the knives. Place the glass jug, without the lid, upside down on a flat
stable surface. You are now able to remove the complete knive assembly. Attention: never try to take the knive assembly apart.
To replace the knives follow the instructions in the reverse order.
• The following parts can be cleaned: the jug, the knive assembly, the lid and the cap. Be careful when cleaning the knive assembly.
The knives are very sharp.
English •
13