Aiwa ADC-M55 YU Mode D'emploi page 3

PRECAUTIONS
Do NOT install the unit in a location where it
may be subjected to:
— Direct sunlight or other sources of excessive
heat
— Fluid, rain or moisture
— Excessive dirt or dust
— Excesswe vibration
This unit is designed to be operated on a 12-volt
DC negative-ground electrical system only.
Choose themounting location carefully so that
the unit will not interfere with normal driving
functions.
Before making connections, dlsconnectthe@
termmal of the car battery to avoid short
circuiting,
Notes on CDs
A defective or soiled disc stored in the disc
magazine can cause the sound to drop out
during play.
Always handle a disc by holding its inner and
outer edges.
@iii
Do NOTtouchthe surface of the unlabeled side
of the disc.
Do NOT attach paper or tape etc. to a disc.
Do NOT expose the discs todirectsunhght or
excessive heat.
Clean the discs before inserting them into the
disc magazine. Always clean a disc from the
center outward with a cleaning cloth.
There may be burrs left on the inner and outer
edges of a brand-new disc. The burr may
cause the malfunction of the unit or sound drop-
out. Topreventthese problems, ifthe burrleft
on the disc, be sure to remove them with a ball-
point pen, etc. as illustrated.
Ball-point pen
Burr
Burr
%
@
Ball-point pen
NEVER usesolvents suchasbenzine oralcohol
to clean a disc.
You cannot play an 8-cm (3-inch) CD — even
with the specially designed adaptor.
Do not use irregular shape CDs (example:
heart-shaped, octagonal ones).
It may result in malfunction.
Notes on the disc magazine
Do NOT leave the disc magazine in a place
subject to excessive temperature or humidity.
Do NOTinsert more than one disc per slot.
Do NOT drop the disc magazine.
ENGLISH
2