Whirlpool OKZ9 6280 SPM WH Guide Rapide page 4

USING THE APPLIANCE FOR THE FIRST TIME
1.
SET THE TIME
You will need to set the time when you switch on the
oven for the first time.
The two digits for the hour will start flashing: Turn the
knob to set the hour and press
The two digits for the minutes will start flashing. Turn
the knob to set the minutes and press
Please note: To change the time at a later point, press and
hold for at least one second while the oven is off and
repeat the steps above.
You may need to set the time again following lengthy power
outages.
2.
SETTINGS
If required, you can change the default unit of
measurement, temperature (°C) and rated current (16 A).
With the oven off, press and hold
seconds.
Turn the selection knob to select the unit of
measurement, then press
DAILY USE
1.
SELECT A FUNCTION
When the oven is off, only the time is shown on the
display. Press and hold
Turn the knob to view the main functions available on
the left-hand display. Select one and press
To select a sub-function (where available), select the
main function and then press
to the function menu.
to confirm.
to confirm.
for at least 5
to confirm.
to switch the oven on.
.
to confirm and go
Turn the selection knob to select the rated current,
then press to confirm.
Please note: The oven is programmed to consume a level of
electrical power that is compatible with a domestic network
that has a rating of more than 3 kW (16 A): If your household
uses a lower power, you will need to decrease this value
(13 A).
3.
HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal.
Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours.
Remove any protective cardboard or transparent film
from the oven and remove any accessories from inside
it.
Heat the oven to 200 °C for around one hour, ideally
using a function with air circulation (e.g. "Forced Air"
or "Convection Bake").
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the first time.
Turn the knob to view the sub-functions available on
the right-hand display. Select one and press
confirm.
2.
SET THE FUNCTION
After having selected the function you require, you
can change its settings.
The display will show the settings that can be
changed in sequence.
TEMPERATURE/GRILL LEVEL
When the °C/°F icon flashes on the display, turn the
knob to change the value, then press
and continue to alter the settings that follow (if
possible).
to
to confirm