Hesperide 171337A Mode D'emploi page 6

CARE INSTRUCTIONS
1/ Your product
Properties
Aluminium is a light, resistant material that doesn't rust.
The top is made of a material consisting of a mixture of calcite powder and PVC (polyvinyl chloride)
extruded and pressed at high temperature and a decorative top layer of PVC. Its surface is non-porous
and easy to clean.
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different
assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric
differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is carried
out individually, before assembly. These metallic elements cannot be free from appearance irregularities
coming both from the surface treatment process and assembly operations. The final appearance of the
product is therefore directly linked to these possible irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to notice that some
threads are not cut after the break point of the seam. There is no risk of the seam becoming undone.
Cut this thread with a simple pair of scissors.
2/ Precautions for use
Do not put hot objects on the table itself, they will leave permanent marks on it (discoloration,
deformation, cracks...). Always use table mats.
Do not use a plastic tablecloth on the table. Exposed to UV and heat, it would melt and act as a decal,
especially on steel, aluminum and glass. This would result in irreparable deterioration of the tray in the
form of white streaks. Instead, use a fabric tablecloth.
Watch out for blows from knives and other sharp objects handled nearby. Watch out too for burns from
cigarettes and from other heat sources.
If you don't use your cushions for a long period, it is advised to put them away to avoid possible
discolouration during too long an exposure to UV rays.
3/ Maintenance and ageing, siding
It is normal to note natural wear and tear of the product over time and with use, in the form of an alteration
of the colours and the state of the surface, the mechanical functions and tightening of the screwed