Lower Anchor Removal & Head Support - Diono monterey XT LATCH Manuel D'instructions

INSTALLATION
IMPORTANT: Do not use UAS if installation interferes with vehicle seat belt.
IMPORTANT: When using booster seat in center seating position, make
sure it is stable and does not rock from side to side.
ADJUSTING THE RECLINE ANGLE
This booster seat features a recline angle that can be
adjusted to match that of the vehicle seat:
1. Push booster seat backrest backwards until you
hear a click. Backrest will now pivot freely and
does not need to click into another position.
2. Push seat bottom and backrest of booster seat
down and back into vehicle seat until there is
secure positioning with the booster seat and
vehicle seat bottom and vehicle seat back. A
gap is acceptable as long as the head support is
touching the vehicle seat back or head rest.
IMPORTANT: It may also be necessary to adjust the
recline angle of the booster seat to match that of the vehicle seat.
16
1-866-954-9786
LOWER ANCHOR REMOVAL & HEAD SUPPORT
DISENGAGING LOWER ANCHOR INSTALLATION
Follow the previous instructions in reverse order.
1. Reach under the bottom of the booster seat and depress the cam
lock lever while pulling the seat away from the vehicle seat back until
the lower anchor straps are extended all the way.
2. Disconnect UAS connectors from vehicle anchors.
3. Pull lower anchor adjuster straps to recess the UAS connectors into
the back of the booster seat bottom for safe storage.
IMPORTANT: Do not use UAS if installation interferes with vehicle seat belt.
ADJUSTING THE HEAD SUPPORT
The head support height can be adjusted for best fit
to your child and to ensure proper placement of the
Vehicle Shoulder Belt. Squeeze the head support
adjustment lever on the back of the booster seat while
adjusting its height up or down to fit the child.
NOTE: It may be easier to adjust backrest width prior to securing the
booster seat installation using UAS.
diono.com
17