Backless Booster Seat - Diono monterey XT LATCH Manuel D'instructions

SECURING THE CHILD
PROPER BUCKLE POSITION
IMPORTANT: After booster seat is installed and seat belt is fastened
around child, it is important to confirm correct seat belt buckle position to
ensure secure installation.
CORRECT SEAT BUCKLE
POSITION
Buckle is on the outside of
lower belt guide.
20
1-866-954-9786
INCORRECT SEAT BUCKLE
POSITION
If buckle is being pulled
across the lower belt guide
and into the seat, choose
another seating position
within the vehicle.
While this booster seat is designed to offer advanced side-impact protection
with its backrest section attached, the seat bottom can also be used alone
as a backless booster.
1. Remove the seat back by reversing the steps shown in "Seat Assembly."
2. Make sure both UAS connectors are securely
attached to the vehicles lower anchors (see
"Lower Anchor Installation"). While pushing
booster against vehicle seat, pull the adjuster
straps tight.
3. Place booster seat on vehicle seat so it is resting firmly
on vehicle seat bottom and touching the vehicle seat
back. The entire seat bottom should sit flat on the
vehicle seat.
4. Properly position child: sitting upright and all the
way back in the booster seat.
5. Fasten seat belt across child.
6. Make sure seat belt is not twisted and lays flat across child's hips,
torso and shoulder.
7. Tighten the seat belt by pulling the diagonal shoulder belt portion in
the direction of the arrows.
NEVER position the shoulder belt loosely or under the child's arm or
behind their back.

BACKLESS BOOSTER SEAT

diono.com
21