Publicité
Les langues disponibles
Les langues disponibles
4.7 Secure Top and Side Mount
For top mount, drive the mounting screws through the
1.
holes in the bracket into the countertop.
For side mount, drive the mounting screws through the
2.
holes in the sides of the cabinetry.
If using the force distributor side mounts, first remove
3.
1
the cutlery rack.
1
Depending on the appliance specifications
Drive the mounting screws through the holes inside the
4.
dishwasher.
Re-insert the cutlery rack.
5.
4.8 Attach the 2-part Toe Panel
Place the slotted toe panel on the dishwasher.
1.
It should rest on the floor.
‒
Position the mating front toe panel on top of the rear toe
2.
panel with the angled edge on the mating edge of the
dishwasher.
To secure the toe panels, drive the two black torx
3.
screws through the holes in the toe panel and the
dishwasher base.
To avoid damaging the dishwasher, use the supplied
‒
screws.
Dishwasher Connection
5 Dishwasher Connection
Follow these instructions to connect the dishwasher.
Dishwasher Connection
5.1 Installing the Water Inlet Connection
The hot water heater should be set to deliver
approximately 120 °F (49 °C) [max. 140 °F/ (60 °C)]
water to the dishwasher. Water that is too hot can cause
Dishwasher Connection en-us
11
Publicité
