FONESTAR MIX-12PRO Mode D'emploi page 6

EN
REAR PANEL
POWER CONSUMPTION: 20 W
~100-240 V AC, 50-60HZ, FUSE: 10AL 250V
1 2
1.- AC power input.
2.- Equipment on/off switch.
CONNECTION
- Before making any connections, make sure that all devices are switched off and disconnected from the
power supply.
- Check that all volume controls on each input and the MAIN MIX output are set to minimum.
- Connect the desired equipment to the input channels.
- If you want to use the player, select the desired mode and then adjust the volume.
- Connect the MAIN MIX output to a line level input of a power amplifier.
- Connect the equipment to the power supply. Switch on the equipment in this order: peripheral equipment,
followed by the MIX-12PRO mixer and lastly the power amplifier (if necessary).
- Adjust the gain of each channel by displaying the channel's CLIP indicator.
- Adjust the volume of each input channel with the volume sliders.
- Adjust the FX (DSP)/SEND volume of each channel if necessary.
- Adjust the volume of the FX effects (DSP) and/or the SEND output bus and RETURN input if necessary.
- Adjust the output level of the MAIN MIX main mix bus with its volume control.
- 6 -
MIX-12PRO
USB/PC 12-CHANNEL MIXER