Publicité
Les langues disponibles
Les langues disponibles
19. You have to obey the corresponding regulation of safety protection, if the weld is used in the
industry.
20. If the weld machine is moved from the cold room to the warm room, the temperature will be
changed, which will cause the congealed water which will affect or damage the components of the
machine, please wait to weld until the temperature of the weld machine is the same with that in the
room.
21. The temperature of the electric soldering irons can reach more than 160°, if the animal or man touch
the metal heated by the electric soldering irons, we will suffer seriously bum.
22. It supposes that the weld machine should not be operated under high temperature.
Preparation
Please conserve the weld machine's packing box. In case that we use it for future transportation or put the
weld machine into it when we don't need it, so as to avoid pollution of ash and the eroding of the wet.
1. Put the metal helix of screw frame into the corresponding open crust of the electric soldering irons
frame. and use the screw to fasten it and so does the bottom of the frame.
2. Please let the sponge for tidying up glue absorb enough clean water and drop to dry, and then put it
on the salver.
3. Fix the frame on the right side of the weld machine (connecting in gap).
Instruction
Don't use the electric soldering iron without soldering mouth because it will damage the heating component
and temperature sensor.
Electrics connect
Please connect the electric soldering iron with the weld machine by means of insetting the plug of the electric
iron lead (a diode plug with 5 conjunctions and 180 degrees lead trough) into the electrical outlet on the face
of the weld machine.
Turn off the switch of the power supply (0 location) and inset the power supply plug of the weld machine lead
into the electrical jack whose voltage conforms with what is marked on the data plate. At that time, the weld
machine is ready for work.
Temperature regulating
1. Put the power supply switch to location 1 and the weld machine is being connected. At that time the
lower line on the screen will display a set temperature.
2. Buttons "+" and "-" increase or decrease the temperature by 1° C. Continuous pressure adjusts the
temperature by 10° at a time until the desired temperature is reached.
3. When the welding temperature is regulated to a wanted number, the factual working temperature will
approach the set temperature gradually.
Publicité
