Publicité
Les langues disponibles
Les langues disponibles
If it is hard to slide the battery cartridge out, push it from the
backside while sliding the button on the front of the cartridge.
Fig.3
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
Fig.4
► 1 . Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the ambient tem-
perature, the indication may differ slightly from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
1
2
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to the motor
to extend appliance and battery life. The appliance will
automatically stop during operation if the appliance or
battery is placed under one of the following conditions.
•
Overload protection : When the appliance or
battery is operated in a manner that causes it to
draw an abnormally high current, the appliance
automatically stops without any indication. In
this situation, turn the appliance off and stop the
application that caused the appliance to become
overloaded. Then turn the appliance on to restart.
•
Overheat protection : When the appliance or
battery is overheated, the appliance automatically
stops. Let the appliance cool down before turning
it on again.
•
Overdischarge protection : When the battery
capacity becomes low, the appliance stops auto-
matically. If the appliance does not operate even
when the switches are operated, remove the
battery cartridge from the appliance and charge it.
OPERATION
Starting / stopping the fan
Press the power switch button to turn on the fan. Press
the power switch button again to turn off the fan.
Changing wind speed
Press the wind speed change button while the fan is
running. The wind speed increases every time you
press the button. The wind speed will return to the
lowest speed when running in the highest speed. The
cordless fan will start in the same speed as the previous
setting.
Fig.5
► 1 . Wind speed change button
6 ENGLISH
1
Publicité
