Knick VariTrans B 13000 Mode D'emploi page 15

2. Intended Use
The Series B 13000 isolated standard signal conditioners are used for galvanic
isolation of 0(4) to 20 mA and 0 to 10 V standard signals. Depending on the
model, input and output signal ranges are permanently set or you can select
calibrated ranges by means of DIP switches. Fine-adjusting is not required for
the models with switch selection. Signal transmission is linear.
The devices can be powered with 230 V AC ± 10 % or
optionally with 24 V AC/DC ± 10 % (Option 336).
Connection is made using screw terminals.
Warning against misuse
Do not operate the device outside the conditions specified by
the manufacturer, as this might result in hazards to operators or
malfunction of the equipment.
CAUTION
The operating company is responsible for the safety of the installation
in which the device is operated.
3. Configuration (B 13000 F1 only)
3.1 Tools
A screwdriver with a width of 3 mm is required to open the device and to
connect the wires to the screw terminals.
3.2 Opening the Device
Disengage the top part of the housing on
both sides using the screwdriver.
Pull out the top part of the housing and
the electronics section until they lock.
15