PNI MAB300LR Manuel Utilisateur page 13

(counted from left to right)
21. and 22. The Motor2 Delay terminal is used to connect the motor 2
installed on the gate that first opens and then closes. Connect here the
first blue wire (counted from left to right). NOTE: If used for a single
gate, connect the motor to the Motor2 Delay terminal
23. 24V AC input: for transformer connection (+)
24. 24V AC input: for transformer connection (-)
25. Digital screen for displaying the settings
26. INC+ used to increase values during settings
27. FUN is for saving the settings
28. DEC- used to lower values during settings
29. Pair button for adding / removing remote controls
Remote control
Button 1: to open a single gate
Button 2: to open a double gate
Button 3: to trigger an alarm
Pairing a remote control
1. Press the LEARN button on the mainboard for a second, the indicator
LED will turn off, which means you have entered the learning mode
2. Press any key on the remote control for more than 2 seconds; on the
digital display on the board the remote control number will be displayed,
and the indicator light will flash 4 times followed by a short beep. The
remote control was successfully learned.
Note: If after pressing the LEARN key, the system receives no signal for 5 seconds,
the LED indicator will turn back on and the system will exit the pairing mode.
Delete a remote control
Press and hold the LEARN button on the mainboard for 5 seconds, a short
beep will be heard and the indicator light will turn on to confirm the remote
control's erasure.
13 User manual