ECOPOSTURAL C3701 Manuel D'instructions page 7

English
To get on the table the patient must seat at the middle of the table, raise his legs and lean on his side.
Then, he can lie down. Weight must necessarily be distributed evenly and not concentrated on either side
of the table.
When getting down the table different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the table, lean
on his side and go up by standing on his arms. He will then be able to put his legs out by the table's side
and easily stand up.
If the patient is lying upwards he will have to stand on his arms, get back to a seated position and then go
down the table.
* Caution: Never use the head or back rest sections to lean forward as these parts are not aimed at
supporting such a pressure.
c) HEIGHT adjustment
The central height of the table is operated by a hydraulic pump.
SAFELY POSITION PATIENT BEFORE TABLE HEIGHT ADJUSTMENT.
Do not insert hands, feet or garments into the moving parts of the elevating mechanism as
this could result in serious injuries.
Press the lever with the foot in order to lift the table. With every stroke the table will go up a few
centimeters. Raise the lever with the foot and the table will get down gently.
d) SECTIONS adjustment
The head-/backrest section is operated by rack (2)
(2) Rack: Lift the section up to the required position and the rack will position itself automatically. To lower
the section, first raise it up to a certain extend or completely (as appropriate) in order to release the rack.
* The hinges on both sides must be properly fixed and positioned at the same height.
NEVER adjust any of the table sections WHILE THE PATIENT IS LEANING ON.
Safely position your FINGERS AND HANDS AWAY from the upholstery edge to avoid any
accidental jamming.
e) ACCESORIES Adjustment
The table you have just purchased is equipped with a set of collapsible side chrome BARS.
To lift the side bar grasp the upper handrail by any of the 2 grips and pull it up till you hear a locking click.
To fold the side bar pull the round knob (at the feet end) outwards for a proper unlocking, hold the side bar
by the grips and take it down.
Always hold the side bar by the grips of the upper handrail.
Before folding the side bar, MAKE SURE THAT NEITHER THE PATIENT OR THE THERAPIST
GET TRAPPED by their hands, feet, limb or any garment between the moving parts of the table.
3) MAINTENANCE
a) Metal FRAME
For a proper operation of the table, you should do the dusting regularly with a cloth.
We also recommend to periodically grease the axles at the moving parts with a liquid grease spray. Lay
the couch on its side and take off the white caps protecting the nuts at the axles of the framework. Slightly
unscrew the nuts and spray the product around the loosen nuts. Leave to settle in this position for 12
hours. Tighten the nuts and put the protective white caps back on. Lay the table on the other side and
repeat.
Periodically check the couch visually for any signs of damage and make sure that all bolts, nuts and other
fasteners are tight.
* Please note that the repeated exposure of the table to high levels of humidity is not recommended.
7