Tripp-Lite PS-406-HGULTRA Manuel Du Propriétaire page 2

Installation
1
Connect Your Power Strip to Your AC Power Line
Plug the power cord into a utility outlet. The power strip's power cord should only be connected
to a standard 3-wire grounded 120V AC 60 Hz outlet.
2
Connect AC Equipment to Your Power Strip
Plug the AC power cords of your equipment into your power strip. Do not use extension cords
or adapters that eliminate the connection to ground. DO NOT OVERLOAD your power strip. Each
outlet can handle a load of up to the model's amp rating, but do not exceed a total load of
more than the model's amp rating for all outlets. If the circuit breaker trips, outlets will cease to
provide power. Reduce the load on the power strip down to your unit's amp rating by unplugging
excess equipment, then depress the circuit breaker button to reset and restore power.
Power Strip Care and Maintenance
Warning: Do not spray with liquid cleaning products.
• To clean, unplug unit and wipe with a clean cloth. Cloth may be dampened with all-purpose
cleaner.
• Check status and operation of LED, if applicable.
• Check Circuit Breaker (CB) status. Normal operation requires CB be depressed.
• Ensure mechanical integrity of case.
• Ensure mechanical integrity of power cord. It should be free of cuts, frays, and exposed wires/
conductors.
• Ensure mechanical integrity of built-in outlet safety covers, if applicable.
• Tripp Lite recommends annual inspection of its products when they are used in a typical hospital/
medical/healthcare/assisted living environment.
17-04-338-933527.indb 2
2
5/5/2017 8:14:37 AM