De Dietrich DPG7340 Serie Guide D'installation Et D'utilisation page 36

• Replace them with injectors for the gas
to be used, as shown in the gas
characteristics table (2.2.4); for this:
• Tighten them by hand as far as
possible.
• Position the spanner fully on the
injector.
• With a pencil, draw a line
base plate at the location shown (1.4.2).
• Turn the spanner clockwise until the
line appears on the other side
(1.4.3).
Do not go beyond this limit; you
could to damage the product.
- Re-fit the burner heads, caps and pan
supports.
Every time you change the type
of gas used, tick the appropriate box
on the label in the wallet. Refer to the
"corresponding
paragraph.
3) Set the retarders on the taps :
these can be
handles (1.4.4).
— Adjust each tap in turn.
— Remove the knobs
washers by pulling them upwards.
— Changing from natural gas to
butane/propane :
- Using a small flat screwdriver, fully
tighten the brass retarders (yellow)
(1.4.5), in a
(1.4.5.1).
- Re-fit the sealing washers and knobs,
ensuring that you orient them correctly
and that the 3 knobs are pushed on
fully.
on the
gas connection"
found under
and sealing
clockwise direction
— Changing from butane/propane to
natural gas
- Loosen the adjusting screws in the
brass retarders (yellow)
using a small, flat screwdriver, by 2
turns anti-clockwise (1.4.5.2).
- Refit the knob
- Light the burner in the maximum
position and then move to the low
position.
- Remove the knob
the adjusting screw clockwise as far as
the lowest possible position before the
flame goes out.
- Re-fit the sealing washer
knob .
- Move the knob from maximum to
minimum a few times: the flame should
not go out; if it does, loosen the
adjustment screw
stays alight during these movements.
1.5 – MARKINGS ON THE
INJECTORS:
the
The table (1.5.2) shows where the
injectors
appliance according to the type of gas
used.
Each number is marked on the injector.
,
26
,
again , then turn
so that the flame
are positioned
(1.4.5),
and the
on your