De Dietrich DPG7340 Serie Guide D'installation Et D'utilisation page 34

1.2 – ELECTRICAL CONNECTION :
Your hob is supplied with a H05V2V2F -
T90 3-core (phase, neutral + earth) mains
cable, section 1 mm2) after sales and
must be connected to a 220-240 V~
single phase mains supply via a phase,
neutral +earth socket meeting standard
IEC 60083 or an omnipolar isolator with a
contact air gap of at least 3.5 mm.
The plug must be accessible after the hob
is installed.
The protective
(green/yellow) is connected to the earth
terminal on the hob and must also be
connected to the
terminal . The fuse for the installation
should be 10 amperes (1.2.1).
If the supply cable is damaged, it must be
replaced by a cable or special set
available from the manufacturer or its
after-sales department.
So that you can find the references
for your appliance without difficulty in the
future, we recommend that you make a
note of them on page (6.1.1) "After-sales
service and customer relations" (that page
also tells you where to find them on your
appliance).
conductor
installation's earth
1.3 – GAS CONNECTION :
If the hob is to be installed above an oven
or if other nearby heating appliances
could heat and damage the gas hose,
then it is essential that a rigid pipe is
installed instead.
If a flexible hose is used (as is the case of
butane gas) then it must not be installed
in a place where it may be in contact with
a moving part of the kitchen unit or a
location likely to get cluttered.
No flexible hoses with a limited
service life may be longer than 2 metres
and must be accessible for inspection
along their entire length. They must be
replaced before their expiry date (printed
on the hose).
connection is chosen, make sure that it is
gastight when installed, using soapy-
water. In France, you must use a hose or
pipe stamped NF Gaz .
The gas connection must comply with the
regulations in force in the country where it
is installed.
• Mains natural gas (1.3.1).
For your safety, you must choose only
one of the following three connections:
Connection via a rigid copper pipe
o
with mechanical screw connectors (½"
gas standard).
• Connect directly on to the elbow on
the appliance.
24
Whatever means of