Klarstein WONDERWALL 45 Mode D'emploi page 23

TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
• Ensure that your circuit breaker or fuse is working properly.
• Be sure the heater is plugged in and that the electrical outlet is working properly.
• If the ON/OFF switch is not illuminated at ON position, send it to service center for
reparation directly.
Note: If you experience a problem with your heater, please see the warranty
information for instructions. Please do not attempt to open or repair the heater
yourself. Doing so may void the warranty and could cause damage or personal
injury. If the problem still persists, please contact the distributor.
CLEANING AND CARE
Before cleaning your heater, switch off the heater and allow it to cool. Disconnect the
electricity supply to the appliance. The outside can be cleaned by wiping it over with
a soft damp cloth and then dried. Do not use abrasive cleaning powders or furniture
polish, as this can damage the surface finish. To release the heater from the wall, for
cleaning or redecoration, just open the screw bolt cap and unscrew the bolts to take off
from the wall.
For short term storage, just plug off the heater and leave it away; for long term storage,
you can dismantle from the wall or cover it with some material.
EN
23