Publicité
Les langues disponibles
Les langues disponibles
EN
FR
DE
ES
IT
NL
Safety, performance, and dependability have been given
top priority in the design of your screwdriver.
INTENDED USE
The screwdriver is intended to be used only by adults who
have read and understood the instructions and warnings
in this manual, and can be considered responsible for their
actions.
The product is intended for fastening and removing
screws and bolts.
Do not use the product in any way other than those stated
for intended use.
NOTE: It is recommended to use pilot holes prior to driving
screws.
WARNING
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
Save all warnings and instructions for future
reference.
DRILL AND SCREWDRIVER SAFETY WARNINGS
Hold power tool by insulated gripping surfaces
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
Hold power tool by insulated gripping surfaces
only when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
CHARGER SAFETY
Do not expose charger to wet or damp conditions.
Use of an attachment not recommended or sold by the
battery charger manufacturer may result in a risk of
To reduce risk of damage to charger body and
cord, pull by charger plug rather than cord when
disconnecting charger.
Make sure cord is located so that it will not be stepped
and stress.
An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
PT
DA
SV
FI
NO
RU
English
PL
CS
HU
RO
LV
LT
If extension cord must be used, make sure:
That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
That extension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord or plug,
which could cause shorting and electric shock. If
damaged, have the charger replaced by an authorised
serviceman.
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way; take
it to a qualified serviceman.
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
To reduce risk of electric shock, unplug the charger
from outlet before attempting any maintenance or
cleaning. Turning off controls will not reduce this risk.
Disconnect charger from power supply when not in use.
Risk of electric shock. Do not touch uninsulated portion
of output connector or uninsulated battery terminal.
Save these instructions. Refer to them frequently and
use them to instruct others who may use this unit.
If you loan someone this unit, loan them these
instructions also.
ADDITIONAL BATTERY SAFETY WARNING
damage due to a short circuit, never immerse your
as seawater, certain industrial chemicals, and bleach
or bleach containing products, etc., can cause a short
circuit.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise, and the operator
should pay special attention to avoid the following:
Damage to hearing caused by noise
Wear suitable hearing protection and limit exposure.
Wear protective eye shields or goggles when using the
product.
1
ET
HR
SL
SK
BG
UK
WARNING
TR
EL
Publicité
