Westfalia WS 230/2600 Mode D'emploi page 39

1. Unscrew the safety hood locking screw (9) and turn to the
desired position.
2. Tighten the safety hood in this position.
Using the Safety Hood for Cutting Discs (1)
1. Remove the safety hood for grinding discs (2).
2. Attach the safety hood for cutting discs (1) on the angle grinder.
 When using cutting discs with the angle grinder, always use the
safety hood (1) that has been designed for use with cutting discs.
 Please note that after work the cutting disc and the workpiece
become very hot. There is risk of burns! Make sure always to use
the right cutting disc for the job.
 When using the angle grinder for cutting, avoit tilting the angle
grinder out of the cutting line. It is advisable to use diamond discs
when cutting hard stone.
 For the best results while rough grinding hold the machine
against the surface in an angle between 30° and 40° in smooth,
even movements.
 Never cut materials containing asbestos with this angle grider.

Secure the workpiece and place suitable wedges under the
workpiece. When operating the angle grinder, do not press the
cutting disc too much on the workpiece. The self weight of the
angle grinder is enough to perform the cut. Avoid overheating the
cutting disc; allow the disc to cool down sufficiently.

Make sure the cutting disc cannot get jammed or laterally
stressed while cutting. The cutting disc must be inserted straight
into the cutting gap of the workpiece.

Always try to cut the workpiece in one go.
ON/OFF Switch
1. To turn the angle grinder on, push the safety lever on the switch
forward and press the ON/OFF switch (4). The angle grinder
starts up.
Operation
35