Publicité
Les langues disponibles
Les langues disponibles
Before first Use
Remove the angle grinder and the accessories for the packaging.
Keep packaging material out of reach of children. There is risk of
suffocation!
Intended Use
This angle grinder is intended for cutting and grinding metal and
stone with the suitable discs.
Setup
Please make sure the power mains voltage corresponds to the
operating voltage stated on the type label.
Attaching the Auxiliary Handle
Do not operate the angle grinder without the auxiliary handle (2).
There are three threaded mounting holes (5) in the transmission
housing, one in each side and one in the middle, to which the
auxiliary handle (2) can be attached.
Turning the Handle
To turn the handle press the unlocking button (3) and turn the
handle 90° to the right ot to the left. Before use make sure the
button hase safely locked into place.
Inserting/Changing the Grinding Disc
Please Note! Always pull the power plug before changing a disc to
avoid accidental starting.
1. Lossen the outer flange with the included face wrench. Keep the
shaft lock (7) pressed to lock the drive shaft and the disc.
2. Insert the cutting disc resp. replace the worn disc. Make sure to
attach the inner flange first, then the cutting disc and finally the
outer flange.
Operation
33
Publicité
