Publicité
Les langues disponibles
Les langues disponibles
Zip HydroTap® G5 BC20
4. Installation
EN
O-Ring
Rubber
seal
Nut
Steam
Boiling
water
Installing Classic, Classic Plus, Touch Free
Note: The tap must not be installed more than 900 mm above the base of the
Tap
undersink unit. Failure to do this may result in poor water delivery.
Note: Under no circumstances should the tap be twisted after the installation is
complete.
Spacer
1. Make sure that the tap location will allow water from the tap to fall into a sink or
other basin fitted with a drain to drain away.
2. Cut a 35 mm diameter hole in the worktop / sink at the place where the tap is to be
installed.
3. Push the black spacer on to the tap from underneath and ensure it remains in
position. A light smearing of silicone sealant on the underside of the spacer will
ensure a watertight fit.
S/S washer
4. Pass the hoses down through the 35 mm hole in the worktop / sink and locate the
tap head on its mounting location.
5. From the underside, push the stainless steel washer over the hoses and then
Spider clamp
push the spider clamp on to the threaded rod of the tap fitting. Secure the spider
clamp with the fastening nut. Check the tap head is in the correct position before
tightening up the nut.
Fixing nut
Installation Arc Plus
Socket
Note: The tap must not be installed more than 900 mm above the base of the
undersink unit. Failure to do this may result in poor water delivery.
Note: Under no circumstances should the tap be twisted after the installation is
complete!
Locking
1. Make sure that the tap location will allow water from the tap to fall into a sink or
washer
other basin fitted with a drain to drain away.
2. Cut a 35 mm diameter hole in the worktop / sink at the place where the tap is to be
installed.
3. Push the chrome-plated pedestal on to the tap from underneath and ensure it
remains in position.
4. Pass the hoses and cables down through the 35 mm hole in the worktop / sink and
locate the tap head on its mounting position.
5. From the underside, push first the rubber seal and the sluice plate over the
Cold
water
hoses / cables, then over the threaded rod of the tap fitting. Secure the sluice
plate with the fastening nut. Check the tap head is in the correct position before
tightening up the nut.
Pay attention to the correct position of the O-ring at the socket.
6. Install the hoses according to the drawing (see left).
22
Publicité
