Publicité
Les langues disponibles
Les langues disponibles
Using the Remote Control
SKIP If you press this button before you change the channel, the TV waits 30 seconds and goes back to the
original channel. Each time you press SKIP, you add 30 seconds (i.e, if you press SKIP two times, the TV waits
60 seconds and turns back to the original channel). Press CLEAR to cancel skip timer.
SOUND Displays the AUDIO PROCESSOR menu.
STOP If you're operating a VCR or DVD player, stops playing the videotape or disc.
TV Turns on the TV and puts the remote in TV mode. Also displays channel information.
VCR Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the VCR
button automatically tunes the TV to the correct channel.
VPORT Tunes the TV to the VPORT input channel. Program this button to control a cable box, audio
components, a VCR, DVD or satellite receiver. When programmed, changes the mode of the remote when the
button is pressed. To restore the VPORT button to factory default mode (unprogrammed), press and hold
VPORT, then press 1, 0, 0, and 0.
VOL (up and down) buttons Decrease or increase the TV's volume.
WHO•INPUT In TV mode, press WHO•INPUT to toggle through the available Video Input channels (FRNT,
VID1/SVID1, VID2/CVID2, VPORT and the current channel). In SAT mode, press to select available channel lists.
Using the WHO•INPUT Button
Use the WHO•INPUT button to toggle through the available input sources (FRNT, VID1/SVID1, VID2/CVID2,
VPORT and the current channel) and view the content from the component you have connected to the TV.
1. Press TV to place the remote in TV mode. Make sure that the content from the component is turned ON.
2. Press WHO•INPUT to tune to the available input source and view the component.
3. Press WHO•INPUT again to tune back to the channel you were previously watching.
Programming the Remote to Operate Other
ON OFF
VCR
Components
DVD
VPORT
AUX
SAT CABLE
The universal remote can be programmed to operate most brands of remote
controllable VCRs, DVD players, audio receivers, satellite receivers and cable boxes.
The remote is already programmed to operate most RCA, GE and Proscan VCRs, DVD
players, audio receivers and satellite receivers. The TV button cannot be programmed.
CLEAR
Find Out If You Need to Program the Remote
REVERSE
PLAY
To determine whether the universal remote needs to be programmed, turn a
STOP
component ON, such as a VCR, point the remote at the VCR, and press the VCR
button. Then press ON•OFF or channel up or channel down to see if the VCR
responds to the remote commands. If not, the remote needs to be programmed.
Use these buttons
when you
How to Program the Remote
program the
There are two ways to program the remote control: automatic code search and direct
remote to operate
entry. Instructions for both ways follow.
another
component.
The remote may
not operate all
models of all
brands.
8
Illustrations contained in this document are for representation only.
Chapter 2
Publicité
