JVC I'Art AV-32F724 Guide De L'utilisateur page 42

Button Functions
Return +
The R + button has two functions:
ETURN
Return - Returns to the channel viewed just before the channel currently onscreen.
Return+ - Lets you program a specific channel to return to while scanning through the channels
using the CH+ and CH– buttons.
R + and hold for three seconds
ETURN
The channel currently active has been programmed as your return+ channel. Now scan through
R +
ETURN
• To cancel your Return+ channel, press and hold the R
message "RETURN CHANNEL CANCELLED!" will appear.
• Return+ works only with the CH+/– buttons. Pressing any number key will cancel Return+.
Input
Selects the signal input source for the television: TV (for Antenna or Cable) or Video-1, 2, or 3
for video devices like VCR's, DVD players, or camcorders.
Press the I
Note:
• You can also access the input menu screen by using the M
instead of the remote control. It appears between INITIAL SETUP and PICTURE ADJUST
screen. Choose the INPUT by pressing M
INPUT by using the C
V-Chip
By pressing the remote control V-
which is being received is displayed on the screen.
If the V-chip rating information is not being sent, "UNRATED" is displayed on the screen.
If the zero ("0") button is pressed while the V-chip rating is displayed on the screen, all
categories with the same or a higher V-chip rating will be blocked.
For example, if you block movies rated NC-17, movies rated X will also be blocked.
• V-chip blocks can be manually set one at a time by using the V-chip option in the INITIAL
SETUP menu. For detailed information about V-chip ratings and V-chip manual settings, refer
to pages 26 to 32.
42
��������������
�����������
the channels using the C
You will return to your programmed channel.
button
NPUT
�� �������
+/- buttons (
HANNEL
button, the V-chip rating information for the program
CHIP
+/– buttons.
HANNEL
ETURN
�������
† on the front panel and select TV or VIDEO
ENU
√ ®
OPERATE ).
+ button for three seconds. The
�������
button on the front of the TV
ENU