turbionaire THEA 50 Manuel D'instructions page 14

How to use the remote control
ON/ OFF Key - used for turning on/off the fan.
Speed plus key - For increasing the speed of the fan; Long press
this icon for Booster setting, will go back to high speed after
operating for 5 minutes.
Speed decrease key - For decreasing the speed of the fan.
Light key - used for turning on/off the light
Gesture control
Gesture sensor
This function is available if the unit is in standby mode.
Motion sensors are activated by passing the hand from left to right or vice versa through the
control panel.
1. Moving the hand from left to right increases the speed level. From boost mode, the same
movement causes the return to minimum speed.
2. Passing the hand from right to left, a function available only when the unit's motor is on,
causes it to enter Quick Timer mode, after which it will stop after 5 minutes. From the Quick
Timer mode, the same movement causes the unit to stop immediately.
The speed level set as a result of the gesture control will be permanently displayed on the
display. In Quick Timer mode, the speed level will be displayed intermittently.
STAINLESS STEEL SURFACES CLEANING
To avoid damaging the stainless steel surface of your appliance
Always clean with:
Soft cloths, distilled or filtered water, as well as detergents specially made for stainless steel.
Do not clean with:
Abrasive materials, cleaning powders, bleach and other chlorine-based products, ammonia-
containing glass cleaners, tap water especially if it tends to be hard water, oven cleaners.
Damage to stainless steel surfaces due to the use of improper cleaning substances is not
covered by the warranty.
Display screen
Gesture sensor