cecotec BOLERO COOLMARKET TT 90 BLACK Manuel D'instructions page 39

To improve the refrigeration system efficiency and save energy, you must ensure good
-
ventilation around the appliance to reduce heat. To do so, there must be enough empty
space around the refrigerator.
It is recommended to ensure a minimum of 100 mm clearance from the back of the
-
refrigerator to the wall, a minimum of 100 mm on the top of the refrigerator, a minimum
of 100 mm from the side of the refrigerator to the wall, and to leave enough space for the
doors to open 135° as shown in Figure 2.
Before use
1. Clean the refrigerator parts with warm water and a soft cloth or with neutral detergent
and clean water, and then dry them.
2. Place the thermostat knob in position 3 and connect the appliance to the electric circuit.
3. The refrigerator compressor will light up.
4. Close the door and wait for 30 minutes. If the storage compartment temperature has
clearly decreased, this indicates that the refrigeration system is working properly.
5. When the refrigerator is in operation for a certain period of time, the temperature controller
will automatically adjust the temperature if you do not open the door too often.
6. If you follow the above steps correctly, your refrigerator is ready for use.
Note: the refrigerator electrical parts must only be cleaned with a dry cloth.
Refrigerator door
This refrigerator has been designed with the door hinges on the right-hand side. If you wish to
change the opening direction, follow these instructions.
Warning
Unplug the appliance from the power supply before reversing the opening direction of the
door. Remove the plug from the socket before starting.
Fig. 3
1. Upper hinge cover
2. Upper hinge fixing screws
3. Upper hinge
4. Adjustable feet
5. Lower hinge
6. Lower hinge fixing screws
7. Adjustable feet
8. Door
1. Remove the upper hinge cover (1) and loosen the upper hinge fixing screws (2). Remove
the upper hinge (3).
BOLERO COOLMARKET TT 90 BLACK / INOX / WHITE
ENGLISH
39