Silverline 976084 Mode D'emploi page 7

Lock ON button
• The Lock ON Button (12) can be used to keep the tool ON without manually holding in the ON/
OFF Trigger Switch (2)
1. To engage the Lock ON Button, press and hold the ON/OFF Trigger Switch then press the Lock ON
Button and release the Trigger Switch; the tool will remain ON
2. To disengage the Lock ON Button, press then release the Trigger Switch; the tool will power OFF
Adjusting the belt speed
• The belt speed of this power belt file can be adjusted using the Variable Speed Dial (3)
1 . Turn the Variable Speed Dial to a higher setting, to increase belt speed
2. Turn the Variable Speed Dial to a lower setting, to decrease belt speed
Note: Adjust belt speed to best suit the work carried out, and to adapt to material requirements.
Also refer to the belt manufacturer's instructions, with regards to speed selection.
Power filing tips
• This power belt file is ideal for intricate sanding and filing tasks at places that are difficult to
access with other tools (see Fig. III)
• Move the machine over the workpiece surface, applying an even, moderate pressure until you
reach the desired surface finish
WARNING: Excessive pressure does not lead to a faster removal of material; it will however
lead to premature wear of the sanding belt, and may cause damage to the machine. Both sanding
performance and quality depend mainly on the choice of the correct sanding belt.
• If there are still scratches on your workpiece after sanding, refer to 'Selecting the right grade
of sanding belt
Accessories
• A full range of sanding belts and accessories is available from your Silverline stockist
Maintenance
WARNING: ALWAYS disconnect from the mains power supply before carrying out any
maintenance/cleaning of the tool
The power belt file contains no user-serviceable parts. If the device does not perform as outlined in
this manual, return it to an authorised Silverline service centre for repair .
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool .
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the device's service life
• Clean the body of your tool with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild detergent
on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes (where
applicable)
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
247820/976084_Manual.indd 7
260W Power Belt File 13mm
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools .com/en-GB/Support
Address:
Toolstream Ltd .
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
Storage
• Store this tool carefully in a secure, dry place out of the reach of childreN
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair .
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
7
12/08/2019 11:35