Télécharger Imprimer la page

Elica HILIGHT-X H16 WH/A/100 Prescriptions De Montage Et Mode D'emploi page 20

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
WARNING! Failure to install the
screws or fixing device in accordance
with these instructions may result in
electrical hazards.
• Do not use or leave the hood without
the lamp correctly mounted due to the
possible risk of electric shocks.
• Never use the hood without effectively
mounted grids.
• The hood must NEVER be used as a
support
surface
indicated.
• Use only the fixing screws supplied with
the product for installation or, if not
supplied, purchase the correct screws
type.
• Use the correct length for the screws
which are identified in the Installation
Guide.
• In case of doubt, consult an authorized
service assistance center or similar
qualified person.
WARNING! Do not use with a
programmer, timer, separate remote
control system or any other device
that switches on automatically.
Electrical connection
The
mains
power
correspond to the rating indicated on the
plate situated inside the hood. If provided
with a plug connect the hood to a socket
in compliance with current regulations
and positioned in an accessible area,
after installation. If it not fitted with a plug
(direct mains connection) or if the plug is
not located in an accessible area, after
installation, apply a double pole switch in
accordance
with
unless
specifically
supply
must
standards
which
assures the complete disconnection of
the mains under conditions relating to
over-current category III, in accordance
with installation instructions.
WARNING! Before re-connecting the
hood circuit to the mains supply and
checking the efficient function, always check
that the mains cable is correctly assembled.
Installation
• The minimum distance between the
supporting
surface
equipment on the hob and the lowest part of
the range hood must be not less than 70cm
from electric cookers and 100cm from gas
or mixed cookers.
If the instructions for installation for the gas
hob specify a greater distance, this must be
adhered to.
Check of the ceiling
The ceiling must be flat, horizontal, sturdy enough, and
resistant
Warnings
The hood is designed to be installed in a dropped ceiling
The dropped ceiling must be sturdy and have a load-bearing
capacity suitable for a product with max. weight of 25 Kg
(model with steel panel) or 30 Kg (model with glass
panel).
Do not install the hood directly in the dropped ceiling panels,
but use a suitable frame or support.
• This appliance is marked according to the European
directive 2012/19/EC - UK SI 2013 No.3113 on Waste
Electrical and Electronic Equipment (WEEE).
• By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
• The symbol
accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it should be taken
to the appropriate collection point for the recycling of electrical
and electronic equipment. Disposal must be carried out in
accordance with local environmental regulations for waste
disposal.
19
for
the
on the product, or on the documents
cooking

Publicité

loading

Ce manuel est également adapté pour:

Hilight-x h16 bl/a/100