Publicité
Les langues disponibles
Les langues disponibles
Zip HydroTap® G5 CS100
5. Use
EN
Chilled, sparkling
water
SELECT
SAFETY
Zip lever
Touch-Free
Hold your hand approx. 1.5 – 5 cm in front of the right sensor to dispense cooled water.
Chilled water flows as long as the hand is held in the sensor area (max. 15 sec.). If the
rear sensor is also triggered, water flows for a period of between 5 and 15 seconds that
can be set in the menu.
Hold your hand approx. 1.5 – 5 cm from the top over the tap to dispense carbonated
sparkling water. Sparkling water flows as long as the hand is held in the sensor area
(max. 15 sec.). If the rear sensor is also triggered, water flows for a period of between 5
and 15 seconds that can be set in the menu.
Note: To ensure smooth functioning of the sensor tap, make sure there is a free
space of min. 10 cm around the sensor head.
Arc Plus / Celsius Arc Plus
Select the desired type of water by tipping to on the Select button on the ZIP lever at
the tap.
• Blue: chilled water
• White: sparkling water
Turn the lever to dispense water. When the lever is turned counterclockwise, water will
flow as long as the lever is held (max. 15 sec.). If the lever is turned clockwise, water
will flow continually for 5 to 15 seconds. This time can be set in the menu. The lever
then has to be manually returned to the Off position.
Blue light (Arc Plus / Classic Plus / Classic)
• On all the time: temperature of chilled water is at the set temperature.
• Flashing: the water has not yet been chilled to the set temperature.
White light (Arc Plus / Classic Plus)
• On all the time: temperature of sparkling water is at the set temperature.
• Flashing: the water has not yet been chilled to the set temperature.
White filter LED (Classic)
• Flashing: the filter needs to be replaced. This LED starts flashing according to filter
use and the filter capacity set in the menu.
Note: For the taps Arc Plus and Celsius Arc Plus the need for a filter replacement is
indicated by cyclically flashing all the LEDs in all three colours
Menu
The undersink unit has a touch screen which can be used to set and read the operating
parameters. By tapping on the three dashes in the top left-hand corner, you can access
the main menu. The following settings can be carried out in the menu:
'General Settings'
Language – Select the language used in the menu.
Date & Time – Set the current date and time.
'System Settings'
The steps that are necessary when using the unit for the first time can be viewed again
for maintenance purposes.
Filter Settings – Filter Flush, Filter Reset, Filter Life
Filter Flush: place the end of the hose located at the filter in a collecting container and
open the isolating valve on the hose before starting to flush the filter.
Filter Reset: resets the filter consumption data.
Temperature Setting – Set the water temperatures.
30
Publicité
