Westinghouse QR043LED Manuel De L'utilisateur page 10

Installation
REMOVING THE ELECTRICAL KNOCK-OUT HOLE
WARNING:
Always wear safety goggles and gloves during
installation .
- Choose the appropriate electrical knock-out hole to remove
for your installation type . Use the top hole (1) if your
electrical supply is in the cabinet and the back hole (2) if
your electrical supply is on the wall below the cabinet (refer
to Fig . 10) .
- Use a hammer and a flathead screwdriver to gently punch
out the electrical knock-out hole.
Fig .10
INSTALLING THE DAMPER (SKIP THIS STEP IF YOU ARE USING INTERIOR VENTING)
NOTE:
Only install the damper if you are using a venting system that does not
already have a damper.
If this hood replaces an existing unit, the location of the air exhaust can vary
from one manufacturer to another. Ensure that the damper fits in the existing
opening before installing.
- Choose to install the damper (C) either in the top
position (3) for top venting or in the back position (4)
for back venting .
- Insert the damper (C) into the chosen hole in the range
hood (A), ensuring that the central flap (6) goes into the hole
while the two side flaps (7) remain above it.
- Lift the lid (8) of the damper and screw the damper (C) to
the range hood (A) with the two short tapping screws (BB) .
- Seal the damper (C) to the range hood (A) on all four sides
with duct tape .
QR043LED
REMOVING THE VENTING HOLE
- Choose the venting hole to remove for your
- Carefully remove the cover (3 or 4) of the appropriate
- If you are venting indoors, unscrew the 2 screws
5
A
3
4
Fig .11
A
8
3
10
installation type . Use the top hole (3) for a top venting
installation and the back hole (4) for a back venting
installation .
venting hole using a flat head screwdriver or needle
nose pliers (refer Fig . 11) . Be careful not to leave any
debris inside the range hood (A) .
holding cover (5) in place and remove the cover as
per Fig . 12 . DO NOT REMOVE ANY OTHER VENTING
HOLE COVER .
Fig .12
A
4
8
BB
BB
C
BB
C
7
Fig . 13
A
5
6
7
C