Toolland TM 76005 Mode D'emploi page 9

TM 76005
HAMMER DRILL
TM 76005
WARNING
Read this manual carefully before using the
machine, for your own safety.
The following symbols are used throughout
this manual:
Always wear safety glasses.
Always wear a safety masque
against dust.
Always wear ear protection when
the sound level noise exceed
85dB(A).
Always wear protection gloves.
In accordance with the European
standards and directives.
Class II – The machine is double
insulated, an earthed wire is not
necessary.
Warning! Risk of personal injury
or damage of the tool or other
objects.
SAFETY INSTRUCTIONS
When using the machine, always observe the
enclosed safety instructions as well as the
additional safety instructions. The following
symbols are used throughout this manual.

Keep work area clean. Cluttered areas
and benches invite injuries.

Keep children away.

Do not let children play with the machine.

Dress properly. Do not wear loose
clothing or jewelry. They can be caught in
moving parts. Wear protective hair
covering to contain long hair.

Use safety glasses, a dust mask and
protection gloves. Also use ear protection
if the noise level exceeds 85 dB(A).
www.toolland.eu

Do not overreach. Keep proper footing
and balance at all times.

Check for damaged parts. Never use a
damaged machine. Damaged parts must
be properly repaired or replaced by an
authorized service center.

Avoid unintentional starting. Always
disconnect tools when they are not in
use. Also before servicing, changing
accessories, ...

Always use a suitable cable according to
the specifications of this machine.

Always keep the area of the power supply
socket free when operating the machine.
You must always be able to disconnect
the machine immediately when
necessary.

Never unplug the machine by pulling the
cable.

Never unplug the supply cord when the
machine is operating.

Do not force the machine. It will do a
better job and operate more safely at the
rate for which it was intended.

Maintain tools with care. Keep tools clean
for better and safer performance.

Consider work area environment. Do not
use electric tools in damp or wet
locations. Keep work area well lit. Do not
use electric tools near flammable liquids
or gases.
ELECTRICAL SAFETY
Always check that the power supply
corresponds to the voltage on the rating
plate.
DESCRIPTION
Your electronic hammer drill has been
designed for drilling in wood, metal, plastic,
stone and concrete and it also has been
designed for screw driving applications.
1. On/off switch
2. Lock button
3. Reverse-rotation lever
(forward/reverse)
4. Hammer drill switch
5. Auxiliary handle
6. Chuck
7. Depth gauge
8. Maximum speed control knob
English
9