Villette le Balade 5 Mode D'emploi Et D'entretien page 7

• When cleaning this bike, please wipe the surface with a piece of soft cloth. For very dirty areas you can
wipe it with a little neutral soap and water.
Warning:
do not wash this electric bike direct with spraying water, especially pressure washers.
Avoid water entering electric components as this may result in damage of the electric components.
3. Operation
Your new electric assistance bicycle is a revolutionary transport means, applying aluminum frame, Li-ion
battery, a super high efficiency electric hub motor and controller with electric pedal assistance system, to
support normal pedaling. The above mentioned equipment will ensure safe riding with excellent function
and performance. It is important for you to note the following guidelines to ensure getting the best
possible experience from your electric bicycle.
Checklist before Riding
3.1.1 Please ensure tyres are fully inflated as indicated on the tyre wall, before riding.
Remember, performance of the bike is directly related to the weight of the rider and baggage/load,
together with the stored energy in the battery;
3.1.2 Charge overnight, prior to riding the next day;
3.1.3 Apply chain oil periodically and clean if dirty or gummed up,using a degreaser, then wipe clean oil
bicycle chain again.
4. Battery installation & usage
The electric bikes have the battery positioned within the rear carrier (the battery pack is directly connected
to the controller box in the front (fig. 2).
The slider of battery is fixed on carrier.
Then the battery case is locked by the key see the operation details below. (Fig. 4.1 Fig. 4.2)
(Fig. 2)
Firstly, please put the battery case along this slider horizontally (as Fig. 2), then push it into and ensure a
snug fit. Second, make sure the battery pack is firmly pushed into the controller housing and its connector
is securely inserted inside the controller box.
7/71