ERMILA Airstyler Mode D'emploi page 8

ENGLISH
· Never use the appliance if it is defective, if it has fallen onto the floor or if the mains cable
de
is damaged. A damaged mains cable may only be replaced with an original replacement
cable by an authorised Service Centre or another similarly qualified person, in order to avoid
en
hazards.
· Repairs may only be performed at an authorised Service Centre using original parts. Only
fr specialists properly trained in the handling of electrotechnical appliances may repair electrical
equipment.
· Only use accessories recommended by the manufacturer.
it
· When disconnecting the appliance from the mains, never pull on the mains cable or on the
appliance itself.
es
· Do not hold the appliance by the mains cable to carry it and do not use the cable as a
handle.
pt
· Do not wind the mains cable around the appliance.
· Keep the mains cable and appliance away from hot surfaces.
nl
· Make sure that the mains cable is not twisted or kinked when used and stored.
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
sv
released.
· Do not expose the appliance to temperatures below 0°C and above +40°C for any length of
time. Avoid direct exposure to sunlight.
no
· The appliance is safety insulated and radio screened. It meets the requirements of EU
Directive 2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive
fi
2006/95/EC.
· We are not liable for damage caused as a result of improper use or failure to observe these
tr
operating instructions.
pl
Operation
· Prior to using the appliance, dry the hair with a towel and comb.
cs
· Connect to the mains power supply.
· The appliance has three temperature / fan settings.
· Switch on the appliance at the on/off switch and select the required temperature / fan setting
sk
(Fig. 1ⓐ).
hu
0 Off
I
Setting 1, for a gentle airflow with warm air
II
Setting 2, for a strong airflow with hotter air
sl
Cold-shot button
❆
ro
· Using the on/off switch, switch off the appliance after use (Fig. 1ⓑ).
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
bg
Attaching/removing round brushes
ru
· Position the round brush and press it onto the housing (Fig. 3ⓐ).
Pay attention to the mark!
uk
· Turn the round brush in the direction of the arrow and lock in position (Fig. 4ⓐ).
· To remove the round brush, press the release button (Fig. 4ⓑ).
el
· Turn the round brush in the direction of the arrow (Fig. 4ⓒ) and remove from the housing
(Fig. 3ⓑ).
ar
8