Beamz COB30UV Mode D'emploi page 6

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX
chain. Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Press off existing modes. Press
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press on the remote controller.
2. Press or to choose between the different auto programs.
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press on the remote controller.
2. Press or to choose between the different sound programs.
To adjust the strobe speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of the program.
3. Press again to turn off the strobe.
To adjust the speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of the program.
To adjust sound sensitivity for in Sound-Active mode
1. Press on the remote controller.
2. Press or to either increase or decrease sound sensitivity.
To enable DMX or disallow DMX on the product.
Press on the remote controller, the product work on the DMX controlling modes.
1. Press on the remote controller.
2. Press to activate the LED.
3. Press again to de-activate the LED.
4. Press or to either increase or decrease the percentage of each colour.
return the last modes.