Velleman CAMZWMBLAH2N Notice D'emploi page 3

CAMZWMBLAH2N & CAMCOLMBLAH2
4. Installation
• The yellow RCA connector is the video output. Connect it to the
video input of a supporting device (e.g. monitor, not incl.).
• The white RCA connector is the audio output. Connect it to the
audio input of a supporting device (e.g. monitor, not incl.)
• Connect the plug of the included power supply to the red jack of
the camera and plug the power adapter in the mains.
• To adjust focus, unscrew the small screw at the bottom of the
lens, turn the lens to adjust and re-secure the screw.
5. Technical Specification
pick-up element
number of pixels
viewing angle
min. illumination
interlace
resolution
video output level
power supply
weight
dimensions
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulted from (incorrect) use of this device.
For more info concerning this product, please visit our
website www.velleman.eu.
The information in this manual is subject to change without
prior notice.
This manual is copyrighted. The copyright to this manual is owned by
Velleman nv. All worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
CAMZWMBLAH2N
1/4" B/W CMOS
352(H)x288(V) CCIR
60°
0.1 Lux / F1.2
9VDC / 200mW (included)
3
CAMCOLMBLAH2
1/3" COLOUR CMOS
628(H)x582(V) CCIR
0.5 Lux / F1.4
2:1
380 TV lines
1.0Vpp 75ohm
68g
38 x 38 x 32mm
92°
®
©Velleman