Beamz Truss Par TP36 Mode D'emploi page 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
The label on the backside of the unit indicates the mains voltage to which it must be connected. Check that the mains voltage corresponds to this. Any
other voltage than the one indicated may cause irreparable damage to the unit. The unit must also be connected directly to the mains voltage and no
dimmer or adjustable power supply may be used.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Press off existing modes. Press
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press on the remote controller.
2. Press or to choose between the different auto programs.
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press on the remote controller.
2. Press or to choose between the different sound programs.
To adjust the strobe speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of the program.
3. Press again to turn off the strobe.
To adjust the speed of the automatic program and the sound active program.
1. Press on the remote controller.
2. Press or to either increase or decrease the speed of the program.
To adjust sound sensitivity for in Sound-Active mode
1. Press on the remote controller.
2. Press or to either increase or decrease sound sensitivity.
return the last modes.