Soozier A91-120 Instructions D'assemblage page 8

I
EN
1.Install the suction cup (G) on the bottom of the base (F), Fix four screws from the low end first
in (E).
2.Fix the connector (E) on base (F) with the wrench (J) and the Screw (l)
3.Insert the upper secttion (C) into the Percussion body (D) and set to the desired height, use the
butterffly screw to fix the upper section into place.
4.Install the rotating rod (B) on the upper end of the adjusting rod (C), install the pipe fitting (N)
onto the main rod (C) and fix it.
5.Put the washer on top of adjusting rod (C) and install the spring (K).
6.Pump up the punch ball by using the pump (H) proided, then screw into position at the top of
the Spring (K).
7.Only use a safe place, well aways from all obstacles, breakaable items or other hazards.
Boxing is a contact sport. Any contact can be dangerous and result in serious injury. When
boxing, be sure you are in good physical condition and under expert supervision.This equipment
will provide limited protection but will not protect you against serious injury. Anyone using this
equipment must assume the risk of any injury.