IPC Gansow 1404-Lion 1460 Manuel D'instructions page 34

The machine features some safety functions that have been described in the chapters concerning the use of both
versions (with or without an engine): for instance, the system for stopping all functions to prevent the battery from running
out or the possibility of turning the red key to disable the self-braking function in the event that the machine has to be
pushed.
SECURITY CODE
PAUSE MOTOR
CHANGE OIL
BRUSH CURRENT
WORN BRUSHES
BATTERY RESERVE
DOWN BATTERY
BATTERY FLAT
ENGLISH
SAFETY AND TROUBLESHOOTING
FAULT DESCRIPTION
Engine thermal overload (machine
shutdown due to traction engine
overload).
Is actuated after 99 hours of operation
of engine.
If current greater than 50A is absorbed
continuously for 10", the function will
be inhibited.
If the jack remains below the brushes
for more than 10" consecutively with
lower microswitch open. Only
message.
If voltage read on KEY line falls below
21.3V (ACID) or 21.7V(GEL) for 3"
consecutively: Only message.
If voltage read on KEY line falls below
20.3V (ACID) or 20.7V(GEL) for 3"
consecutively.
If voltage read on KEY line falls below
18.0V (ACID) or 18.3V(GEL) for 3"
consecutively.
REMEDY
1 Check traction engine
intake with wheel raised: must be
less than 30A .
2 Check operation of temperature
sensor in traction engine (it is closed
when cold).
To reset the alarm, after changing the
oil, press the display switch for 5"
whilst the oil meter is displayed.
Error can be reset only by switching
off the machine or actuating the new
preset programme.
Can be reset only by switching off
machine.
Reset if voltage returns to 24.0V for
.
3" consecutively
Reset if voltage returns to 24.0V for 3"
consecutively. All functions except
traction are inhibited. Recharge the
battery.
Reset if voltage returns to 21.3V for 3"
consecutively. All functions and
traction are inhibited. Recharge the
.
battery
power
14