JVC KW-XR610 Manuel D'instructions page 29

Category Menu item
10
FADER *
BALANCE *
LOUD
Loudness
VOL ADJUST
Volume adjust
L/O MODE
Line output
mode
SUB.W FREQ *
Subwoofer cutoff
frequency
SUB.W LEVEL *
Subwoofer level
* 10 If you are using a two-speaker system, set the fader level to "00."
* 11 This adjustment will not affect the subwoofer output.
* 12 Displayed only when <L/O MODE> is set to <SUB.W>.
Selectable setting, [
R06 – F06
[ 00 ]
11
L06 – R06
[ 00 ]
• LOUD ON
• LOUD OFF
VOL ADJ –05 —
VOL ADJ +05
[ VOL ADJ 00 ]
• SUB.W
• REAR
12
• LOW
• MID
• HIGH
12
SUB.W 00 —
SUB.W 08
[ SUB.W 04 ]
Initial: Underlined
: Adjust the front and rear speaker output
balance.
: Adjust the left and right speaker output
balance.
: Boost low and high frequencies to produce a
well-balanced sound at a low volume level.
: Cancels.
: Preset the volume adjustment level of
each source (except FM), compared to the
FM volume level. The volume level will
automatically increase or decrease when you
change the source.
• Before making an adjustment, select the
source you want to adjust.
• "VOL ADJ FIX" appears on the display if "FM" is
selected as the source.
: Select if the REAR LINE OUT terminals are
used for connecting a subwoofer (through an
external amplifier).
: Select if the REAR LINE OUT terminals are
used for connecting the speakers (through an
external amplifier).
: Frequencies lower than 72 Hz are sent to the
subwoofer.
: Frequencies lower than 111 Hz are sent to the
subwoofer.
: Frequencies lower than 157 Hz are sent to the
subwoofer.
: Adjust the subwoofer output level.
]
ENGLISH 29