Philips SBCRU530/88 Mode D'emploi page 6

Instructions for use
All manuals and user guides at all-guides.com
ADVANCED TIPS AND TRICKS
A
D V I C E
Carefully read the complete procedure before starting!
Changing the device keys
With the mode selector it is possible to select 3 categories of
devices you want to operate. Each category (TV, VCR and SAT)
is meant to operate a specific group of equipment:
TV VCR
tv vcr
Once you have programmed the functions of a device in one
of the categories, it is not possible to program another device
in the same category. There is, however, a solution in case
you want to program two devices in the same category
(2 TV's, VCR's, etc.). The following example explains how.
EXAMPLE:
The SAT mode on this remote control is factory preset to
control many Philips satellite receivers. You can change the
SAT mode (or any mode) to operate another type of device.
The following example shows you how to use the SAT mode to
TV VCR SAT
operate a second TV:
1
Press the mode selector key to select SAT and make sure
the second TV is switched on.
2
Press and hold keys 1 and 6 simultaneously - for about
1 6
3 seconds - until the green LED lights up.
3
On the keypad, press keys 9, 9 and 2.
9 9 2
4
Press the mode selector key to select TV mode.
5
Press key 1.
1
– The LED flashes twice to indicate successful set up.
That's it!
Don't forget to set up the SBC RU530 to operate this second
TV. See the section Set-up for use.
Punch-Through Sound
Punch-through sound enables you to control the audio level of
your first or second TV, regardless of what device mode the
remote control is in.
EXAMPLE:
You have installed a second TV under SAT mode. You can
control that TV's volume when you are in VCR mode. This
feature is installed as a default setting for a first TV.
To install this feature for a second TV:
6
SAT
sat
cable