Publicité
Les langues disponibles
Les langues disponibles
Adjusting saw chain tension
CAUTION:
Do not tighten the saw chain too
much. Excessively high tension of saw chain may
cause breakage of saw chain and wear of the guide
bar.
CAUTION:
A chain which is too loose can
jump off the bar and it may cause an injury
accident.
The saw chain may become loose after many hours of use.
From time to time check the saw chain tension before use.
1.
Loosen the retaining nut a bit to loosen the
sprocket cover lightly.
Fig.12
► 1. Retaining nut
2.
Lift up the guide bar tip slightly and adjust the
chain tension. Turn the chain adjusting screw counter-
clockwise to tighten, turn it clockwise to loosen.
Tighten the saw chain until the lower side of the saw
chain fits in the guide bar rail as illustrated.
1
2
3
Fig.13
► 1. Guide bar 2. Saw chain 3. Chain adjusting screw
3.
Keep holding the guide bar lightly and attach the
sprocket cover.
Make sure that the saw chain does not loose at the
lower side.
4.
► 1. Retaining nut
Optional accessory
You can change the angle of the tool head by attaching
the angled attachment to the tool.
1.
2.
1
remove the pipe and sleeves from the head of the tool.
► 1. Sleeve 2. Bolt
3.
► 1. Cap
12 ENGLISH
Tighten the retaining nut to secure the sprocket cover.
Fig.14
Installing or removing the angled attachment
CAUTION:
Before installing or removing the angled
attachment, be sure to attach the guide bar cover to the tool.
Attach the guide bar cover to the tool.
Loosen 2 bolts with the hex wrench, and then
1
2
Fig.15
Remove the caps from the angled attachment.
Fig.16
1
1
Publicité
