Toparc SUNCOLOR 3 Mode D'emploi page 4

Translation of the original instructions
OPERATING INSTRUCTIONS
TECHNICAL DATA
Light Source
Luminous Power
Operating time
Battery Specification
Charging Time
Charging Input
Degree of protection
Operating temperature
WARNING
• Do not open the device.
• Do not look directly into the light emitting lamp - Risk of eye injuries!
• Do not operate in direct sun light or extreme temperature conditions.
• Operating temperature, -10°C to +40°C.
• Keep away from children! Children should be supervised in order to ensure that they do not play with the device!
OPERATING & CHARGING PROCEDURE
• SUNCOLOR 3 Operating mode as below
To change the luminous power :
- Press the switch first time : 2700 K - 350 lm.
- Press the switch second time : 4500 K - 420 lm.
- Press the switch third time : 6500 K - 450 lm. The light will be automatically switch to ECO mode (350 lm) after
5 minutes.
- Press the Switch fourth time, whole light switch off.
• Switch lamp off and put light onto the base, and connect with USB charger during charging.
• The battery indicator will blink during charging.
• All the battery indicator will stay lighting up after finished the charging.
• If the battery indicator did not light up, please remove the charger and try again. Always only use the charger
recommended by the manual to charge the lamp. The use of a NON-recommended charger can lead to a fire and
destroy the lamp.
• Before taking the hand lamp into service for the first time charge it for 4-5 hours. Fully charge the hand lamp be-
fore it is stored for a longer period.
SAFETY INSTRUCTIONS
• Do not use the device if there is damage to the housing, plug or cable. Consult your local authorized specialist!
• Do not open the device! Repair work and replacing the rechargeable battery pack may only be carried out by elec-
tricians.
• Carry out cleaning tasks only when the mains plug is removed from the mains power!
• There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned and trained persons.
Please contact your nearest authorized branch.
• Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and moisture. Danger of
explosion.
• If the battery is damaged or not used correctly. Fluids can leak from the battery. Avoid contact with these. Leaking
battery fluids can lead to skin irritation or burns. Rinse off with water if you should come into contact. If the fluid
gets into your eyes,make sure you get medical help.
• The lamp is not allowed to be placed on the light surface while being switched on.
4
LED PORTABLE LAMP SUNCOLOR 3
Keep this instruction manual for future reference or for subsequent possessors.
Light Source : Quick Color Controller – 3 Color
ca. 450 lumen ‒ Full Power Mode
ca. 420 lumen
ca. 350 lumen ‒ ECO Mode
ca. 2 h max.
Li-Ion 3.7 V, 2600 mAh, 9.62Wh
ca. 4 h
DC 5V 1A
IP 65, IK 07
‒10 °C to +40 °C
EN