Samsung NX58M3310S Serie Manuel D'installation page 23

Anti-Tip
bracket
*approximately
21/32" (16.5 mm)
Screw must enter
wood or concrete
To check if the bracket is installed and engaged properly, remove storage drawer
and look underneath the range to see that the leveling leg is engaged in the
bracket. Carefully tip the range forward. The bracket should stop the range within
4 inches (10.2 cm) of tipping. If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
Step 5. Plug in and place
*NOTE: To install the Anti-Tip
WARNING
bracket, release the leveling
leg. A minimum clearance of
BEFORE OPERATING OR TESTING, follow the grounding requirements on pages 14-
21/32" (16.5 mm) is required
15 in this manual. Improper connection of the grounding plug can result in a risk
between the range bottom
of electric shock.
and the kitchen floor.
All gas ranges come with a power cord. The power cord is connected to the
•
rear of the range. Please review "Electrical requirements" on pages 14-15.
• All U.S. and Canadian models are produced with a 3-wire, 120-volt, 60-Hertz
electrical system. The entire system, including the power cord, is preinstalled
and prewired
1. Plug in the power cord. Make sure the
outlet meets local or national electrical
codes as referenced on pages 14-15.
2. Slide the range into place.
3. Check the gas supply line to make sure
it did not get damaged and it stayed
Gas Range Plug
connected during positioning.
4. Check to make sure the back leg of the
range has slid into the anti-tip bracket.
Carefully tip the range forward to
ensure that the anti-tip bracket engages
the back brace and prevents tip-over.
English 23