Axis Communications F44 Guide D'installation page 11

• When routing the sensor unit cable, the minimum bending
radius is 40 mm.
The sensor unit is delivered with a cable. To shorten the cable follow
these steps:
1. Cut the cable to the desired length. Measure from the sensor
unit.
2. Strip the plastic outer coating from the end of the cable.
3. Peel back the shield.
4. Flatten the colored wires in the order described below.
1
Brown
2
White/brown
3
Not used
4
Not used
5
White/blue
6
Blue
5. Insert the wires all the way into a shielded 6P6C RJ12
connector.
NO NO TICE NO TICE TICE
Make sure that the wires stay in the correct order and that the
cable shield makes good contact with the connector shield.
6. Use a crimping tool to fasten the connector to the cable.
AXIS F44 Dual Audio Input
11