Publicité
Les langues disponibles
Les langues disponibles
English - EN
WARNING:
Maintenance and repairs performed by unauthorized personnel could result in damage or injury.
Maintenance and repairs must be performed by authorized personnel only. Keep all fasteners tight.
Keep adjustments according to specifications.
WARNING:
Electrical components of this machine can "short-out" if exposed to water or moisture. Keep the
electrical components of the machine dry. Wipe the machine down after each use. For storage, keep
the machine in a dry building.
WARNING:
To prevent damage to the power cord, do not let the brush, pad, pad driver or wheels touch the power
cord when the machine is running. Always lift the cord over the machine. Do not pull the power cord
to move the machine.
WARNING:
Always use a three-wire electrical system connected to the electrical ground. For maximum protection
against electric shock, use a circuit that is protected by a ground fault interrupter. Consult your electrical
contractor.
WARNING:
Operating a machine without observing all labels and instructional information could result in injury
or damage. Read all machine labels before attempting to operate. Make sure all of the labels and
instructional information are attached or fastened to the machine. Get replacement labels and decals
from your authorized distributor.
WARNING:
Use of this machine as a step or furniture could result in injury or damage. Do not use this machine
as a step or furniture. Do not ride on this machine.
WARNING:
To avoid injury keep hands, feet and loose clothing away from all moving parts of this machine.
WARNING:
Risk of explosion. Floor sanding can result in an explosive mixture of fine dust and air. Use floor
sanding machine only in a well-ventilated area free from any flame or match.
WARNING:
This machine is not to be used on pressure treated wood. Some pressure treated woods contain
arsenic and sanding pressure treated wood produces hazardous dust. Inhaling hazardous dust from
pressure treated wood can cause serious injury or death. Sanding pressure treated wood decks or
uneven surfaces can damage the machine, which is not covered under warranty or damage waiver.
WARNING:
Any alterations or modifications of this machine could result in damage to the machine or injury to the
operator or other bystanders. Alterations or modifications not authorized by the manufacturer voids
any and all warranties and liabilities.
WARNING:
Injury to operator or bystanders could occur if an abrupt change in floor surface texture is encountered
when using this machine. Abrupt change in floor surface texture can cause a sudden pulling motion
by this machine. This sudden pulling motion can result in loss of control of the machine which could
injure the operator or bystanders. Avoid motions that could cause machine to cross from a smooth
floor surface to a carpeted or rough texture floor surface Avoid motions that could allow the machine
to come in contact with low obstacles, such as floor electrical outlets, door stops or entry molding, etc.
WARNING:
Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor
surface. These areas can cause a dangerous condition for the operator or other persons. Always put
CAUTION signs near the area being cleaned.
CAUTION:
The machine is heavy. Get assistance before attempting to transport or move it.
CAUTION:
This machine is intended for commercial use only.
Operator Safety Instructions (continued)
5
Section - A
Publicité
