Amano Pioneer Eclipse FM2000 Manuel De L'opérateur page 10

Section - A
How to Start/Stop the Machine
WARNING: Never start a polisher when the handle is
in the vertical position.
The switch to start and stop the machine is activated
by the interlock switch and the levers under the handle
grips (see Figure 9). To start the machine, follow this
procedure:
1. Lower the handle.
2. Lock the handle in the best position for operation.
(see Figure 8).
Apply
Pressure to
Lock
Figure 8
10
WARNING: Control the safety interlock switch with
hands only.
NOTE: Make sure you hold the handle with both
hands
3. Push the interlock switch first and then apply
pressure to the levers.
Figure 9
NOTE: Hold the handles loosely for the best control
of the machine. Too much movement makes the
machine difficult to control.
WARNING: Water solutions or cleaning materials
used with this type of machine can leave wet
areas on the floor surface. These areas can cause
a dangerous condition for the operator or other
persons. Always put CAUTION signs near the area
being cleaned.
English - EN