Husqvarna 128PS Manuel D'utilisation page 7

• Use gloves when necessary, for example when
you attach, examine or clean the cutting
equipment.
• Use sturdy non-slip boots.
• Use clothing made of a strong fabric. Always
use heavy, long pants and long sleeves. Do
not use loose clothing that can catch on twigs
and branches. Do not wear jewelry, short pants,
sandals or go with bare feet. Put your hair up
safely above shoulder level.
• Keep first aid equipment close at hand.
Safety devices on the product
WARNING:
instructions that follow before you use
the product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. Refer
Maintenance schedule on page 15 .
to
• If the safety devices are damaged or do not
operate correctly, speak to your Husqvarna
servicing dealer.
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
1780 - 003 - 04.09.2023
Read the warning
A
2. Push down the throttle trigger lockout and make
sure that it goes back to its initial position when
you release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that
the saw chain stops and stay stationary.
WARNING:
moves when the throttle trigger is in
the idle position, then the carburetor
idle speed must be adjusted. Refer
To adjust the idle speed on page
to
21 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and
make sure that the engine stops.
To do a check of the muffler
WARNING:
that has a damaged muffler.
If the saw chain
Do not use a product
7