Functional Description - Milwaukee M18 2623-20 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour M18 2623-20:

Manuel de l'utilisateur (12 pages)

Table Des Matières

Table des Matières

Les langues disponibles

• Under abusive conditions, liquid may be ejected

from the battery; avoid contact. If contact ac-

cidentally occurs, flush with water. If liquid

contacts eyes, additionally seek medical help.

Liquid ejected from the battery may cause irritation

or burns.

• Do not use a battery pack or tool that is dam-

aged or modified. Damaged or modified batteries

may exhibit unpredictable behavior resulting in fire,

explosion or risk of injury.

• Do not expose a battery pack or tool to fire or

excessive temperature. Exposure to fire or tem-

perature above 265°F (130°C) may cause explosion.

• Follow all charging instructions and do not charge

the battery pack or tool outside the temperature

range specified in the instructions. Charging im-

properly or at temperatures outside the specified range

may damage the battery and increase the risk of fire.

SERVICE

• Have your power tool serviced by a qualified repair

person using only identical replacement parts. This

will ensure that the safety of the power tool is maintained.

• Never service damaged battery packs. Service

of battery packs should only be performed by the

manufacturer or authorized service providers.

SPECIFIC SAFETY RULES FOR

PLANER

Planer safety warnings:

• Wait for the cutter to stop before setting the tool

down. An exposed rotating cutter may engage the

surface leading to possible loss of control and seri-

ous injury.

• Use clamps or another practical way to secure

and support the workpiece to a stable platform.

Holding the work by your hand or against the body

leaves it unstable and may lead to loss of control.

• Inspect and remove nails from the workpiece

before cutting. Nails will damage the tool and could

result in fragments of nail or blade being thrown

toward the operator.

• Use only sharp, properly paired planer blades.

Always change blades in pairs. Dull or improperly

paired blades may cause binding, gouging, or loss

of control, causing injury.

•Keep hands and body away from blades. Hold

tool securely with both hands. Contact with

blade will result in serious injury.

• Blades are sharp. Use care when changing or

adjusting blades.

• Before use, ensure blade bolts are tight and

blades are properly aligned. Run the tool to check

for vibration or "wobble" that could indicate improp-

erly installed blades.

• Keep hands and fingers away from dust chute.

Turn off tool and remove battery pack before clearing

jams.

• Maintain labels and nameplates. These carry

important information. If unreadable or missing,

contact a MILWAUKEE service facility for a free

replacement.

•

Some dust created by power sanding,

WARNING

sawing, grinding, drilling, and other

construction activities contains chemicals known to

cause cancer, birth defects or other reproductive

harm. Some examples of these chemicals are:

• lead from lead-based paint

• crystalline silica from bricks and cement and other

masonry products, and

• arsenic and chromium from chemically-treated

lumber.

Your risk from these exposures varies, depending on

how often you do this type of work. To reduce your

exposure to these chemicals: work in a well ventilated

area, and work with approved safety equipment, such

as those dust masks that are specially designed to

filter out microscopic particles.

SYMBOLOGY

Volts

Direct Current

No Load Revolutions per Minute (RPM)

UL Listing for Canada and U.S.

SPECIFICATIONS

Cat. No. ..................................................... 2623-20

Volts.............................................................. 18 DC

Battery Type .................................................M18™

Charger Type................................................M18™

Recommended Ambient

Operating Temperature ......................0°F to 125°F

No Load RPM ......................................... 0 - 14,000

Max Planing Depth ......................................... 5/64"

Max Rabbeting Depth ................................... 27/64"

Max Planing Width......................................... 3-1/4"