Beamz PARTYBAR 2 Manuel D'instructions page 6

REMOTE CONTROL
With the IR remote, you can operate the
To control the fixture you must aim the remote at the front of the fixture and be no more than
30 feet away.
1. On/Off
2. AUTO MIX: With this button you can choose 10 auto programs for the Par and the
Jellymoon. To select the desired program, press several times on auto mix until
the desired effect.
3. PAR: Only the LED par in the auto program. You can choose between 13 auto
programs. To select the desired program, press several times on PAR until the
desired effect.
4. LED: Only the Jellymoon in the auto program. You can choose between 7 auto
programs. To select the desired program, press several times on LED until the
desired effect.
5. Sound Mix: With this button you can choose 10 sound programs for the par and
the jellymoon.
until the desired effect.
6. PAR: Only the LED par in the sound program. You can choose between 10 sound
programs. To select the desired program, press several times on PAR until the
desired effect.
7. LED: Only the jellymoon in the sound program. You can choose between 7 sound
programs. To select the desired program, press several times on LED until the
desired effect.
8. DMX mode
9. PAR JUMP
10. GRADUAL
11. FLASH
Colour - / +
Motor -/ +
Sen -/ +
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
6
Party Bar easy and you have many functions.
To select the desired program, press several times on Sound mix
: Par jump chase.
: Par fade mode.
: Strobe
: With this button you can change your speed of your effect.
: Jellymoon speed rotation.
: Sensitivity sound.
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.