EINHELL 43.012.71 Mode D'emploi D'origine page 12

Anleitung_RT_TC_520_U_SPK1:_
GB
Damage to hearing if the ear-muffs specified are
not used.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Important instructions
4.1. General
Please read this manual carefully and pay particular
attention to the instructions contained within it. Use
this information to get to know the machine, its
correct operation and safety regulations (see
supplementary sheet) before using for the first time.
4.2. Additional safety instructions
Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
same as your supply voltage. Only then are you
to insert the power plug in the socket-outlet.
Wear safety goggles.
Wear ear-muffs.
Wear safety gloves.
Never use cracked diamond cutting wheels.
Replace immediately.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
Never leave the machine unattended in rooms
with children.
Always pull out the power plug before examining
the electric motor compartment system.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
12
17.02.2010 9:35 Uhr Seite 12
5. Technical data
Motor rating
Motor speed
A.c. motor
Insulation material class
Insulation
Cut length
Jolly length
Cut height 90°
Cut height 45°
Cutting table:
Dimensions
Diamond cutting wheel
Laser class
Laser wavelength
Laser output
Laser power supply
Weight
Noise emission levels
The noise emitted by this saw is measured in
accordance with EN ISO 3744; EN ISO 11201
The noise at the workplace may exceed 85 dB
(A). The user will require noise protection
measures if this is the case. (Wear ear-muffs!)
Sound pressure level L pA 94 dB(A)
Sound power level L WA
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
800 W
3000 rpm
230 V ~ 50 Hz
Class B
IP54
520 mm
520 mm
max. 30 mm
max. 25 mm
570 x 385 mm
ø 200 x ø 25.4
2
650 nm
< 1 mW
2 x 1.5 V (AAA)
31 kg
With-load No-Load
operation operation
76 dB(A)
107 dB(A) 89 dB(A)