NEKTRA PRO 1031050 Guide D'utilisation page 17

CLEANING THE HEPA FILTER
The HEPA filter is located in the filter unit in the dust container and should be cleaned regularly to ensure that the suction
power of your vacuum cleaner is not reduced and that the motor is not overloaded.
To put the dust container and the filter unit back together, you must insert the filter unit
11
so that the upper arrow points towards the lower empty arrow.
Turn the dust container lid until the upper arrow points towards the lower white arrow
12
and locks itself in place.
Insert the dust container into the vacuum cleaner. You should hear a click when it is locked
13
in place.
Hold down the release button on the handle of the dust container and remove the dust
1
container from the vacuum cleaner.
2 Open the dust container by unlocking and lifting up the dust container lid.
3 Remove the HEPA filter by pulling it out.
Tap the HEPA filter out over an open dustbin. Clean the filter using a brush if necessary.
4
Never clean the HEPA filter with water.
5
Insert the HEPA filter back into the filter unit.
6 Relock the dust container lid.
Insert the dust container back into the vacuum cleaner. You should hear a click
7
when it is locked into place.
9